How Much It Costs to Ship a Car to or from Frisco
Cost is the first question on almost every call, and the honest answer is that it depends on distance more than anything else. Published long-distance moves to and from Texas run between $625 and $1,365 for an operable vehicle on an open carrier. That range reflects mileage: rates work out to roughly $0.80 per mile on shorter hauls and settle to about $0.65 per mile once a route passes 1,000 miles.
The variables that push a quote up or down are consistent: how large the vehicle is, whether it starts and steers, whether it goes on an open or an enclosed trailer, and how tight the pickup date is. Flexibility is the cheapest thing to give — a two or three day window is materially less expensive than a fixed date.
Very short hauls are the exception. Below roughly 650 miles the per-mile arithmetic stops describing what a carrier actually needs to run the load, so those moves are quoted on their own rather than off a table.
Routes and Transit Times from Frisco
I-35 is the corridor that shapes most Texas moves. It runs from Laredo through San Antonio, Austin, Waco and Dallas to Oklahoma.
This is why proximity to the corridor matters more than raw distance. Carriers assemble a load along a line and fill it as they go, so an address near the interstate joins a truck sooner. Addresses further out are still served — the pickup window simply runs a day or two longer.
Transit time is governed by hours-of-service rules, which cap a driver at eleven driving hours in a fourteen-hour window. In practice that is 400 to 500 miles a day. Cross-country is seven to ten days door to door, regional moves are one to three.
Pickup and transit are two separate clocks. Assigning a carrier to a Frisco address typically takes one to five days depending on the lane and the season; the drive begins after that.
Open or Enclosed: Choosing Equipment for a Texas Move
Open transport is what roughly nine out of ten vehicles ship on. It is the standard eight to ten car trailer, it is the cheapest option, and it is what new cars ride on from the factory to the dealer. Enclosed transport costs meaningfully more and exists for vehicles where road exposure is the thing you are paying to avoid.
Distance, not weather, drives Texas pricing — an in-state move from El Paso to Houston is longer than New York to Chicago. Summer heat above 100F shifts loading to early mornings from June through September, and the rare ice event shuts down the I-35 corridor around Dallas for a day or two each winter.
For a daily driver moving to or from Frisco, open is almost always the right call. For a classic, a low-clearance sports car, a fresh restoration or anything where the paint is part of the value, enclosed is worth the difference.
Getting the Vehicle Ready for the Driver
Start by washing the car. The inspection report the driver fills out at pickup is what a claim is judged against weeks later, and a layer of road grime conceals precisely the marks that end up being argued about.
Run the tank down to roughly a quarter. Fuel is dead weight on a trailer and there is no reason to pay to move it. Pull the toll transponder out before it starts billing you for gantries you never drove under, fold the mirrors in, drop the antenna, and empty the cabin — personal items sit outside the carrier’s cargo policy entirely.
Disable the alarm, or leave clear instructions for it. An alarm that cycles for two days on a trailer is a real problem for a driver. Finally, photograph the vehicle from every corner on the day of pickup and keep your copy of the signed bill of lading; those two things together resolve almost every dispute that ever arises.
Frisco Car Shipping: Common Questions
How much does it cost to ship a car to or from Frisco?
Long-distance moves to and from Texas generally fall between $625 and $1,365 for a running vehicle on an open carrier. Rates run near $0.80 per mile on shorter hauls and around $0.65 per mile beyond 1,000 miles. Vehicle size, operability, trailer type and how flexible your dates are all move the final figure.
How long does it take to ship a car to or from Frisco?
There are two clocks. Assigning a carrier to a Frisco pickup usually takes one to five days. Once the vehicle is loaded, a truck covers 400 to 500 miles a day under federal hours-of-service limits — so a regional move is one to three days on the road and a cross-country move is seven to ten.
Do I need open or enclosed transport?
Open transport suits around nine in ten vehicles and costs less. Choose enclosed for classics, low-clearance cars, recent restorations or anything where paint condition is part of the value — and consider it for a winter move through Texas if road salt is a concern.
Can the truck come to my door in Frisco?
Usually, but not always. A full-size carrier is around 75 feet long and cannot manage narrow residential streets, low branches or tight cul-de-sacs. When an address will not work, the driver arranges to meet nearby — a supermarket or shopping-center lot is standard practice and does not change the price.
Is my vehicle insured while it is being shipped?
Yes. Every carrier we assign has active cargo insurance in force, and you can request the certificate before pickup. Personal items left in the vehicle are not covered by that policy, which is one of the reasons to empty the car first.
Can I ship a car that does not run?
Yes, with notice. An inoperable vehicle needs a carrier with a winch and takes longer to load, so it costs more and needs to be declared when you book. Tell us whether it rolls, steers and brakes — those three things decide what equipment is sent.
